CNS 630-S

STATIONARY WING SHEARS

• Precompression of cut scrap using two swing-mounted side plates – wings
• The width and height of the scrap is reduced and the entire contents is compressed into a square
• The clamp pushes the scrap into the shearing area
• The holder pushes the scrap and the blade sledge shears it
• The entire cycle is automatic
• Scrap can be charged into the tilting hopper during shearing and then dumped out into the open charging chambre at the end of the cycle
• The shears are controlled either directly from the operating cabin or from the portable panel by the loading operator

Side view of the CNS 630 shears

Catalogue Sheet in PDF format